New Operations Hub Episode: Shop Layout
Episode 4 looks at some the best practices and emerging trends and technologies that could influence how contractors will lay out their floors in the future.
In the latest episode of the Operations Hub, Seth is joined by Paul Candelaria (Miller Bonded), Todd Hill (Ventcon), and Joseph Lansdell (Poynter Sheet Metal) to talk about some of the particulars when it comes to successfully laying out a sheet metal shop floor. The panel talks about some of the best practices, some of the pitfalls they've run into in their careers and some of the emerging trends and technologies that could influence how contractors will lay out their floors in the future.
Sep 11, 2024 — Member Update
Latest Articles
Jul 1, 2026 - Modules focus on sections related to Duct Classifications, Critical Loads, and Panel Gage & Stiffener Selection
Jul 1, 2026 - The current Acting Secretary has led the Department since April, and SMACNA looks forward to continuing its relationship with DOL’s leadership to expand registered apprenticeship opportunities and enhance related workforce policies.
Jul 1, 2026 - Scholarship Program identifies and recognizes academically talented youth and potential future leaders within the SMACNA extended family to provide opportunities to further their education and develop their talents.
Privacy Policy |
Terms of Use | Contact Us
Phone: 703.803.2980 | Email:
info@smacna.org
© 1998-2026 SMACNA. All rights reserved.
Web Design & Development by Matrix Group
International, Inc.
